Display contig information in a graphical or tabular view

SeqMan Ultra’s data display views allow you to perform in-depth analysis on a contig created as part of a SeqMan NGen assembly.

These views can be accessed using commands in the View menu, but the fastest way to access them is to use the toolbar to the right of the Explorer panel. Available tools vary depending on the type of assembly.

*Note: Once two views are open, subsequent views will open in separate moveable and resizable windows. To reattach the views, see Customize the look and layout.

Image	Tool Name	Shortcut to Menu Command	Description
	Show alignment view of selected contigs	View > Alignment	Causes one Alignment view to open for each selected contig.
	Show strategy view of selected contigs or scaffolds	View > Strategy	Causes one Strategy view to open for each selected contig or scaffold.
	Show table of features in selected contigs	View > Features	Causes one Features View to open for each selected contig.
	Show table of SNPs in selected contig	View > Variants	This option is only available for reference-guided .assembly projects and causes one Variant View to open for each selected contig.
	Show report view of selected contigs	View > Contig Report	Causes one Contig Report View to open for each selected contig. This view comes in three versions: Contig Information, Contig Coverage, Contig Structural Variation. By default, the Contig Information tab is shown.

SeqMan Ultra allows multiple instances of a view to be created, some of which may share a common view tab. As shown in the image below, the view tab shows how many views of that type are in that tab folder. To display a different instance, hover over the view tab until you see a popup showing each instance by name, then click on the desired instance.